Polder Pumps have been developed from the proven Submersible Pump design with advanced technology to replace Vertical Turbine Pumps & Centrifugal Pumps. Polder Pump is not only economical but also saves space, cost and easy to install,operate and maintain.

The construction of the pump is 'Pump below, Motor above' and suction inlet is at the bottom so that water is pumped from the lowest level.

Polder pumpset is single/two stages Centrifugal Pump with impellers of mixed flow design. The water to be lifted flows through a passage tube and is pumped around the motor and up into the discharge main.

Motor is wet type, filled with clear water & suitable for working under water. Motor design is of squirrel cage induction type and is wound with special PVC insulated winding wire.

Mechanical Seal is provided to prevent the entry of sump water into the Motor. Axial thrust is controlled by adequate thrust bearing.

Polder pumps are available in a wide range of models. This pump can take turbidity upto 10000 ppm and handles maxium particle size upto 8 mm.

Material of construction is offered according to the application.

It is a portable type Pump and can easily be shifted from one site to another site and is also ideal for fixed installation.